
Have a warm bath before using your hair removal cream/spray this will ensire that your hairs are slightly softer and your pores are open and will maximise the products effectiveness.
INSTRUCTIONS
Please read the instructions before use and follow exactly.
1. Shake the can well before using.
2. Over the bathtub, spray the legs from about 10cm to create an even layer of foam.
3. Let stand 3 to 5 minutes then test a small area by removing a bit of foam with your fingertips. If hair does not remove easily leave spray on a few more minutes. Do not exceed 10 minutes in total.
4. Remove the cream spray with a wet wash cloth then rinse the area immediately with warm water without soap. Do not rub in.
5. Wipe the spray mechanism after use.
CAUTION
Follow the instructions exactly. Use only as directed. Pressurised container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do not pierce or burn, even after use. Do not spray on a naked flame or any incandescent material. Do not breathe vapour. Use only in well ventilated areas. If swallowed seek medical advice immediately and show this container or label. Keep away from sources of ignition. No smoking. Irritation or allergic reaction may occur with some people, even after prior use without adverse effect, therefore test before each use by applying product to a small part of the area where hair is to be removed. Follow directions and wait 24 hours. If skin appears normal, proceed with full application. Do not use on irritated, sunburned, inflamed or broken skin. Do not use on face, around eyes, in nose, ears or on breast nipples, perianal, or vaginal/genital areas. Strongly alkaline. Contains alkali, avoid contact with eyes. In the event of contact with eyes, rinse immediately with plenty of water and seek medical advice. Contains thioglycolate. Keep out of reach of children.
Contact Us | Terms | Policies | Site Map
Nair is a registered trademark of Church & Dwight Co., Inc.
© Church & Dwight UK Ltd. 2008. All Rights Reserved